nfc_hal_post_reset.h revision e9df6ba5a8fcccf306a80b1670b423be8fe7746a 
1/******************************************************************************
2 *
3 *  Copyright (C) 2009-2012 Broadcom Corporation
4 *
5 *  Licensed under the Apache License, Version 2.0 (the "License");
6 *  you may not use this file except in compliance with the License.
7 *  You may obtain a copy of the License at:
8 *
9 *  http://www.apache.org/licenses/LICENSE-2.0
10 *
11 *  Unless required by applicable law or agreed to in writing, software
12 *  distributed under the License is distributed on an "AS IS" BASIS,
13 *  WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
14 *  See the License for the specific language governing permissions and
15 *  limitations under the License.
16 *
17 ******************************************************************************/
18
19/******************************************************************************
20 *
21 *  Post NCI reset routines
22 *
23 ******************************************************************************/
24#ifndef NFC_HAL_POST_RESET_H
25#define NFC_HAL_POST_RESET_H
26
27
28/*****************************************************************************
29** Application control block definitions
30******************************************************************************/
31#define NFA_APP_PATCHFILE_MAX_PATH          255
32
33typedef struct
34{
35    UINT8 prm_file[NFA_APP_PATCHFILE_MAX_PATH+1];   /* Filename of patchram */
36    UINT8 *p_prm_buf;                               /* Pointer to buffer for holding patchram data */
37
38    /* Patchfile for I2C fix */
39    UINT8 prm_i2c_patchfile[NFA_APP_PATCHFILE_MAX_PATH+1];
40    UINT8 *p_prm_i2c_buf;
41
42    UINT8 userial_baud;
43
44    tNFC_HAL_DEV_INIT_CFG dev_init_config;
45
46    /* snooze mode setting */
47    UINT8 snooze_mode;
48    UINT8 idle_threshold_dh;
49    UINT8 idle_threshold_nfcc;
50    UINT8 nfc_wake_active_mode;
51    UINT8 dh_wake_active_mode;
52
53} tNFC_POST_RESET_CB;
54extern tNFC_POST_RESET_CB nfc_post_reset_cb;
55
56/*
57** Post NCI reset handler
58**
59** This function is called to start device pre-initialization after NCI CORE-RESET.
60** When pre-initialization is completed,
61** HAL_NfcPreInitDone() must be called to proceed with stack start up.
62*/
63void nfc_hal_post_reset_init (UINT32 brcm_hw_id, UINT8 nvm_type);
64
65
66#endif  /* NFC_HAL_POST_RESET_H */
67