Lines Matching refs:PFX
45 #define PFX DRV_NAME " "
149 DBG(PFX "%s: phy write timeout\n", hw->dev[port]->name);
153 DBG(PFX "%s: phy I/O error\n", hw->dev[port]->name);
177 DBG(PFX "%s: phy read timeout\n", hw->dev[port]->name);
180 DBG(PFX "%s: phy I/O error\n", hw->dev[port]->name);
899 DBGIO(PFX "queue %#x idx <- %d\n", q, idx);
979 DBG(PFX "%s: receiver stop failed\n", sky2->netdev->name);
1169 DBG2(PFX "%s: ram buffer %dK\n", dev->name, ramsize);
1206 DBGIO(PFX "%s: le bases: st %p [%x], rx %p [%x], tx %p [%x]\n",
1253 DBGIO(PFX "%s: tx queued, slot %d, len %d\n", dev->name,
1293 DBGIO(PFX "%s: tx done %d\n", dev->name, idx);
1323 DBG2(PFX "%s: disabling interface\n", dev->name);
1433 DBG(PFX "%s: Link is up at %d Mbps, %s duplex, flow control %s\n",
1456 DBG(PFX "%s: Link is down.\n", sky2->netdev->name);
1470 DBG(PFX "%s: remote fault\n", sky2->netdev->name);
1475 DBG(PFX "%s: speed/duplex mismatch\n", sky2->netdev->name);
1519 DBGIO(PFX "%s: phy interrupt status 0x%x 0x%x\n",
1577 DBGIO(PFX "%s: rx slot %d status 0x%x len %d\n",
1611 DBG2(PFX "%s: rx length error: status %#x length %d\n",
1621 DBG2(PFX "%s: FIFO overflow error\n", dev->name);
1626 DBG2(PFX "%s: rx error, status 0x%x length %d\n",
1682 DBG2(PFX "status OP_RXCHKS but checksum offloading disabled\n");
1696 DBG(PFX "unknown status opcode 0x%x\n", opcode);
1714 DBGIO(PFX "%s: hw error interrupt status 0x%x\n", dev->name, status);
1717 DBG(PFX "%s: ram data read parity error\n", dev->name);
1723 DBG(PFX "%s: ram data write parity error\n", dev->name);
1728 DBG(PFX "%s: MAC parity error\n", dev->name);
1733 DBG(PFX "%s: RX parity error\n", dev->name);
1738 DBG(PFX "%s: TCP segmentation error\n", dev->name);
1758 DBG(PFX "PCI hardware error (0x%x)\n", pci_err);
1773 DBG(PFX "PCI-Express error (0x%x)\n", err);
1791 DBGIO(PFX "%s: mac interrupt status 0x%x\n", dev->name, status);
1819 DBG(PFX "%s: descriptor error q=%#x get=%d [%llx] last=%d put=%d should be %d\n",
1831 DBG(PFX "error interrupt status=%#x\n", status);
1906 DBG(PFX "unknown chip ID!\n");
1954 DBG(PFX "unsupported revision Yukon-EC rev A1\n");
1984 DBG(PFX "unsupported chip type 0x%x\n", hw->chip_id);
2039 DBG(PFX "ignoring stuck error report bit\n");
2190 DBG(PFX "etherdev alloc failed\n");
2220 DBG2(PFX "%s: addr %s\n", dev->name, netdev_addr(dev));
2280 DBG(PFX "cannot allocate hardware struct\n");
2288 DBG(PFX "cannot map device registers\n");
2304 DBG2(PFX "Yukon-2 %s chip revision %d\n",
2320 DBG(PFX "cannot register net device\n");
2333 DBG(PFX "allocation for second device failed\n");
2335 DBG(PFX "register of second port failed (%d)\n", err);