Cross Reference: /arch/arm/mach-omap2/serial.c

Lines Matching defs:uart
48  * stay on until power/autosuspend_delay is set for the uart from sysfs.
110 				struct omap_uart_state *uart)
112 	uart->default_omap_uart_pads[0].name = rx_pad_name;
113 	uart->default_omap_uart_pads[0].flags = OMAP_DEVICE_PAD_REMUX |
115 	uart->default_omap_uart_pads[0].enable = OMAP_PIN_INPUT |
117 	uart->default_omap_uart_pads[0].idle = OMAP_PIN_INPUT | OMAP_MUX_MODE0;
118 	uart->default_omap_uart_pads[1].name = tx_pad_name;
119 	uart->default_omap_uart_pads[1].enable = OMAP_PIN_OUTPUT |
121 	bdata->pads = uart->default_omap_uart_pads;
122 	bdata->pads_cnt = ARRAY_SIZE(uart->default_omap_uart_pads);
126 						struct omap_uart_state *uart)
134 		rx_fmt = "uart%d_rx.uart%d_rx";
135 		tx_fmt = "uart%d_tx.uart%d_tx";
137 		rx_fmt = "uart%d_rx_irrx.uart%d_rx_irrx";
138 		tx_fmt = "uart%d_tx_irtx.uart%d_tx_irtx";
155 		 * Check if uart is used in default tx/rx mode i.e. in mux mode0
159 			omap_serial_fill_uart_tx_rx_pads(bdata, uart);
164 		struct omap_uart_state *uart)
184 		struct omap_uart_state *uart;
188 			 "uart%d", num_uarts + 1);
193 		uart = kzalloc(sizeof(struct omap_uart_state), GFP_KERNEL);
194 		if (WARN_ON(!uart))
197 		uart->oh = oh;
198 		uart->num = num_uarts++;
199 		list_add_tail(&uart->node, &uart_list);
201 				"%s%d", OMAP_SERIAL_NAME, uart->num);
204 			console_uart_id = uart->num;
208 				pr_info("%s used as console in debug mode: uart%d clocks will not be gated",
209 					uart_name, uart->num);
233 	struct omap_uart_state *uart;
248 	list_for_each_entry(uart, &uart_list, node)
249 		if (bdata->id == uart->num)
254 	oh = uart->oh;
276 	pdev = omap_device_build(name, uart->num, oh, pdata, pdata_size);
290 	oh->dev_attr = uart;
307 	struct omap_uart_state *uart;
310 	list_for_each_entry(uart, &uart_list, node) {
311 		bdata.id = uart->num;
316 		omap_serial_check_wakeup(&bdata, uart);
321 			omap_serial_init_port(&bdata, &info[uart->num]);