Searched refs:and (Results 1 - 25 of 33) sorted by relevance
12
/net/irda/ |
H A D | Kconfig | 12 infrared communication and is supported by most laptops and PDA's.
|
/net/netlabel/ |
H A D | Kconfig | 11 protocols such as CIPSO and RIPSO. For more information see 13 for configuration tools and additional documentation.
|
/net/mpls/ |
H A D | Kconfig | 8 that have had MPLS stack entries pushed onto them and thus
|
/net/x25/ |
H A D | Kconfig | 12 network. Governments, banks, and other organizations tend to use it 16 if you want that) and the lower level data link layer protocol LAPB 19 You can read more about X.25 at <http://www.sangoma.com/tutorials/x25/> and 22 <file:Documentation/networking/x25.txt> and 29 Ethernet card and the LAPB over Ethernet (say Y to "LAPB Data Link 30 Driver" and "LAPB over Ethernet driver" below).
|
/net/can/ |
H A D | Kconfig | 12 (NMEA2000), industrial, and medical applications. 16 If you want CAN support you should say Y here and also to the 36 sending of RTR frames, and cyclic CAN messages without permanent user 37 interaction. The BCM can be 'programmed' via the BSD socket API and 47 The CAN Gateway/Router is used to route (and modify) CAN frames. 48 It is based on the PF_CAN core infrastructure for msg filtering and 49 msg sending and can optionally modify routed CAN frames on the fly.
|
/net/openvswitch/ |
H A D | Kconfig | 12 programmatic extension and flow-based control of the network. This 15 which are often characterized by highly dynamic endpoints and the 20 which is able to accept configuration from a variety of sources and 23 See http://openvswitch.org for more information and userspace 41 Say N to exclude this support and reduce the binary size. 54 Say N to exclude this support and reduce the binary size. 67 Say N to exclude this support and reduce the binary size.
|
/net/atm/ |
H A D | Kconfig | 9 and Wide Area Networks. It uses a fixed packet size and is 14 ATM networking card. If you have that, say Y here and to the driver 25 Classical IP over ATM for PVCs and SVCs, supporting InARP and 47 ELAN and Ethernet segments. You need LANE if you want to try MPOA. 54 bridges and ATM attached hosts establish direct ATM VCs across
|
/net/bluetooth/ |
H A D | Kconfig | 17 It was designed as a replacement for cables and other short-range 24 HCI device and connection manager, scheduler 26 L2CAP (Logical Link Control and Adaptation Protocol) 38 utilities like hciconfig and bluetoothd. These utilities and updates
|
/net/8021q/ |
H A D | Kconfig | 8 Select this and you will be able to create 802.1Q VLAN interfaces 11 firewalling, bridging, and of course IP traffic. You will need 38 supersedes GVRP and is not backwards-compatible.
|
/net/rxrpc/ |
H A D | Kconfig | 15 These are used for AFS kernel filesystem and userspace utilities. 17 This module at the moment only supports client operations and is 41 Provide kerberos 4 and AFS kaserver security handling for AF_RXRPC
|
/net/unix/ |
H A D | Kconfig | 9 sockets are the standard Unix mechanism for establishing and 11 the X Window system and syslog use these sockets even if your 18 correctly if you say M here and then neglect to load the module.
|
/net/netlink/ |
H A D | Kconfig | 9 reduces overhead by avoiding copying data between kernel- and
|
/net/batman-adv/ |
H A D | Kconfig | 15 http://www.open-mesh.org/ for more information and user space 25 to both the same LAN and the same mesh. If you will never use 27 this feature and save some space. 37 this option you can safely remove it and save some space. 51 can safely disable it and save some space.
|
/net/bridge/netfilter/ |
H A D | Kconfig | 45 bridging and routing frames, giving Linux the functionality of a 46 brouter. See the man page for ebtables(8) and examples on the ebtables 55 local input, forwarding and local output. See the man page for 82 and/or destination address on a list of addresses. Optionally, 90 This option adds the ARP match, which allows ARP and RARP header field 119 If you want to compile it as a module, say M here and read 127 This value is the same as the one used in the iptables mark match and 182 This value is the same as the one used in the iptables mark match and
|
/net/ax25/ |
H A D | Kconfig | 2 # Amateur Radio protocols and AX.25 device configuration 11 and more specifically about AX.25 on Linux 31 microphone input and speaker output) supporting the KISS protocol or 34 and parallel port hacks or the sound card modem (supported by their 57 from clients (called "slaves") and redistributes it to other slaves. 72 from clients (called "slaves") and redistributes it to other slaves. 102 connections in general and amateur radio AX.25 connections in
|
/net/hsr/ |
H A D | Kconfig | 11 and it must be connected as a node in a ring network together with 24 You need to perform any and all necessary tests yourself before
|
/net/l2tp/ |
H A D | Kconfig | 17 possible to both end-users and applications. 30 and session setup). One such daemon is OpenL2TP 63 L2 protocols, including ATM, Frame Relay, HDLC and even raw 77 L2TP frames, namely UDP and plain IP (without UDP). This 96 used as a control protocol and for data encapsulation to set
|
/net/lapb/ |
H A D | Kconfig | 10 connection service to exchange data frames with one other host, and 15 to use LAPB connections over Ethernet, say Y here and to "LAPB over
|
/net/rfkill/ |
H A D | Kconfig | 8 found on many WiFi and Bluetooth cards. 49 rfkill_gpio_platform_data structure and pass that to the driver.
|
/net/tipc/ |
H A D | Kconfig | 17 can be inserted in and removed from the running kernel whenever you 19 as a module, say M here and read <file:Documentation/kbuild/modules.txt>.
|
/net/ipv4/ |
H A D | Kconfig | 10 of the Internet which carries audio and video broadcasts. More 18 computer that forwards and redistributes network packets, say Y; you 28 file system support" and "Sysctl support" below and executing the 50 For details about rp_filter strict and loose mode read 60 Useful for testing and measuring TRIE performance. 75 and <ftp://post.tepkom.ru/pub/vol2/Linux/docs/advanced-routing.tex>. 90 equal "cost" and chooses one of them in a non-deterministic fashion 99 received packets which look strange and could be evidence of an 110 This enables automatic configuration of IP addresses of devices and [all...] |
/net/ipv6/ |
H A D | Kconfig | 145 another protocol and sending it over a channel that understands the 147 the notion of a secure tunnel for IPSEC and then use routing protocol 158 another protocol and sending it over a channel that understands the 191 Support for IPv6-in-IPv6 and IPv4-in-IPv6 tunnels described in 202 another protocol and sending it over a channel that understands the 204 GRE (Generic Routing Encapsulation) and at this time allows 226 normal and source prefix specific routes in the same routing table 228 avoided by defining different routing tables for the normal and 245 Normally, a multicast router runs a userspace daemon and decides 246 what to do with a multicast packet based on the source and [all...] |
/net/ipv4/netfilter/ |
H A D | Kconfig | 33 This option enables /proc and sysctl compatibility with the old 61 fields such as the source, destination, type of service and 86 The IPv4 NAT option allows masquerading, port forwarding and other 98 packet transformations such as the source, destination address and 99 source and destination ports. 156 The packet filtering and full NAT (masquerading, port forwarding, 202 # `filter', generic and specific targets 208 rules for simple packet filtering at local input, forwarding and 231 The SYNPROXY target allows you to intercept TCP connections and 233 server. This allows to avoid conntrack and serve [all...] |
/net/9p/ |
H A D | Kconfig | 23 guest partitions and a host partition.
|
/net/decnet/ |
H A D | Kconfig | 8 Digital (now Compaq). It provides reliable stream and sequenced 19 Be sure to say Y to "/proc file system support" and "Sysctl support" 24 inserted in and removed from the running kernel whenever you want). 35 network link driver", "Routing messages" and "Network packet
|
Completed in 262 milliseconds
12