Searched refs:wl1271_debug (Results 1 - 24 of 24) sorted by relevance

/drivers/net/wireless/ti/wl12xx/
H A Devent.c57 wl1271_debug(DEBUG_EVENT, "MBOX vector: 0x%x", vector);
60 wl1271_debug(DEBUG_EVENT, "status: 0x%x",
68 wl1271_debug(DEBUG_EVENT,
H A Dscan.c51 wl1271_debug(DEBUG_SCAN, "band %d, center_freq %d ",
54 wl1271_debug(DEBUG_SCAN, "hw_value %d, flags %X",
57 wl1271_debug(DEBUG_SCAN,
61 wl1271_debug(DEBUG_SCAN, "beacon_found %d",
195 wl1271_debug(DEBUG_CMD, "cmd scan stop");
328 wl1271_debug(DEBUG_CMD, "cmd sched_scan scan config");
358 wl1271_debug(DEBUG_SCAN, "filter_type = %d", cfg->filter_type);
428 wl1271_debug(DEBUG_CMD, "cmd periodic scan start");
474 wl1271_debug(DEBUG_CMD, "cmd periodic scan stop");
H A Dcmd.c117 wl1271_debug(DEBUG_CMD, "FEM autodetect: %s, manufacturer: %d\n",
185 wl1271_debug(DEBUG_CMD, "FEM autodetect: %s, manufacturer: %d\n",
295 wl1271_debug(DEBUG_ACX, "cmd channel switch");
H A Dmain.c669 wl1271_debug(DEBUG_BOOT, "chip id 0x%x (1271 PG20)",
694 wl1271_debug(DEBUG_BOOT, "chip id 0x%x (1283 PG20)",
1041 wl1271_debug(DEBUG_BOOT, "pause1 0x%x", pause);
1069 wl1271_debug(DEBUG_BOOT, "soft reset bootdata 0x%x", boot_data);
1131 wl1271_debug(DEBUG_BOOT, "clk2 0x%x", clk);
1167 wl1271_debug(DEBUG_BOOT, "ACX_EEPROMLESS_IND_REG");
1177 wl1271_debug(DEBUG_BOOT, "chip id 0x%x", tmp);
1332 wl1271_debug(DEBUG_TX,
1348 wl1271_debug(DEBUG_TX,
1510 wl1271_debug(DEBUG_PROB
[all...]
/drivers/net/wireless/ti/wl18xx/
H A Devent.c64 wl1271_debug(DEBUG_EVENT,
85 wl1271_debug(DEBUG_EVENT, "SMART_CONFIG_DECODE_EVENT_ID");
108 wl1271_debug(DEBUG_EVENT, "MBOX vector: 0x%x", vector);
111 wl1271_debug(DEBUG_EVENT, "scan results: %d",
119 wl1271_debug(DEBUG_EVENT,
H A Dcmd.c36 wl1271_debug(DEBUG_ACX, "cmd channel switch");
87 wl1271_debug(DEBUG_CMD, "cmd smart config start group_bitmap=0x%x",
115 wl1271_debug(DEBUG_CMD, "cmd smart config stop");
141 wl1271_debug(DEBUG_CMD, "cmd smart config set group key id=0x%x",
H A Dacx.c35 wl1271_debug(DEBUG_ACX, "acx cfg bitmap %d blk %d spare %d field %d",
68 wl1271_debug(DEBUG_ACX, "acx checksum state");
94 wl1271_debug(DEBUG_ACX, "acx clear statistics");
118 wl1271_debug(DEBUG_ACX, "acx peer ht operation mode hlid %d bw %d",
158 wl1271_debug(DEBUG_ACX,
H A Dtx.c133 wl1271_debug(DEBUG_TX, "tx status id %u skb 0x%p success %d",
154 wl1271_debug(DEBUG_TX, "last released desc = %d, current idx = %d",
H A Dmain.c659 wl1271_debug(DEBUG_BOOT, "chip id 0x%x (185x PG20)",
717 wl1271_debug(DEBUG_BOOT, "clock freq %d (%d, %d, %d, %d, %s)", clk_freq,
875 wl1271_debug(DEBUG_BOOT, "chip id 0x%x", tmp);
1055 wl1271_debug(DEBUG_TX, "tx_fill_hdr: hlid: %d "
1233 wl1271_debug(DEBUG_ACX, "using wide channel rate mask");
1239 wl1271_debug(DEBUG_ACX, "using MIMO channel rate mask");
1251 wl1271_debug(DEBUG_ACX, "using wide channel rate mask");
1260 wl1271_debug(DEBUG_ACX, "using MIMO rate mask");
1498 wl1271_debug(DEBUG_CRYPT, "extra spare keys before: %d",
1524 wl1271_debug(DEBUG_CRYP
[all...]
H A Dscan.c176 wl1271_debug(DEBUG_CMD, "cmd sched_scan scan config");
299 wl1271_debug(DEBUG_CMD, "cmd periodic scan stop");
/drivers/net/wireless/ti/wlcore/
H A Devent.c39 wl1271_debug(DEBUG_EVENT, "RSSI trigger metric: %d", metric);
100 wl1271_debug(DEBUG_EVENT, "PERIODIC_SCAN_COMPLETE_EVENT (status 0x%0x)",
116 wl1271_debug(DEBUG_EVENT, "%s: roles=0x%lx allowed=0x%lx",
139 wl1271_debug(DEBUG_EVENT, "%s: roles=0x%lx success=%d",
166 wl1271_debug(DEBUG_EVENT, "DUMMY_PACKET_ID_EVENT_ID");
198 wl1271_debug(DEBUG_EVENT, "remove sta %d", h);
207 wl1271_debug(DEBUG_EVENT, "MAX_TX_FAILURE_EVENT_ID");
214 wl1271_debug(DEBUG_EVENT, "INACTIVE_STA_EVENT_ID");
221 wl1271_debug(DEBUG_EVENT, "REMAIN_ON_CHANNEL_COMPLETE_EVENT_ID");
274 wl1271_debug(DEBUG_EVEN
[all...]
H A Dps.c44 wl1271_debug(DEBUG_PSM, "elp work");
67 wl1271_debug(DEBUG_PSM, "chip to elp");
133 wl1271_debug(DEBUG_PSM, "waking up chip from elp");
165 wl1271_debug(DEBUG_PSM, "wakeup time: %u ms",
188 wl1271_debug(DEBUG_PSM, "entering psm (mode=%d,timeout=%u)",
217 wl1271_debug(DEBUG_PSM, "leaving psm");
290 wl1271_debug(DEBUG_PSM, "start mac80211 PSM on hlid %d pkts %d "
321 wl1271_debug(DEBUG_PSM, "end mac80211 PSM on hlid %d", hlid);
H A Dacx.c43 wl1271_debug(DEBUG_ACX, "acx wake up conditions (wake_up_event %d listen_interval %d)",
73 wl1271_debug(DEBUG_ACX, "acx sleep auth %d", sleep_auth);
103 wl1271_debug(DEBUG_ACX, "acx dot11_cur_tx_pwr %d", power);
133 wl1271_debug(DEBUG_ACX, "acx feature cfg");
163 wl1271_debug(DEBUG_ACX, "acx mem map");
178 wl1271_debug(DEBUG_ACX, "acx rx msdu life time");
205 wl1271_debug(DEBUG_ACX, "acx slot");
234 wl1271_debug(DEBUG_ACX, "acx group address tbl");
272 wl1271_debug(DEBUG_ACX, "acx service period timeout");
304 wl1271_debug(DEBUG_AC
[all...]
H A Dio.c145 wl1271_debug(DEBUG_IO, "mem_start %08X mem_size %08X",
147 wl1271_debug(DEBUG_IO, "reg_start %08X reg_size %08X",
149 wl1271_debug(DEBUG_IO, "mem2_start %08X mem2_size %08X",
151 wl1271_debug(DEBUG_IO, "mem3_start %08X mem3_size %08X",
H A Ddebug.h78 #define wl1271_debug(level, fmt, arg...) \ macro
84 #define wl1271_debug(level, fmt, arg...) \ macro
H A Dboot.c185 wl1271_debug(DEBUG_BOOT, "starting firmware upload");
187 wl1271_debug(DEBUG_BOOT, "fw_data_len %zd chunk_size %d",
228 wl1271_debug(DEBUG_BOOT, "uploading fw chunk 0x%p to 0x%x",
241 wl1271_debug(DEBUG_BOOT, "uploading fw last chunk (%zd B) 0x%p to 0x%x",
260 wl1271_debug(DEBUG_BOOT, "firmware chunks to be uploaded: %u", chunks);
272 wl1271_debug(DEBUG_BOOT, "chunk %d addr 0x%x len %u",
385 wl1271_debug(DEBUG_BOOT,
456 wl1271_debug(DEBUG_BOOT, "chip id after firmware boot: 0x%x", chip_id);
497 wl1271_debug(DEBUG_MAILBOX, "cmd_box_addr 0x%x", wl->cmd_box_addr);
506 wl1271_debug(DEBUG_MAILBO
[all...]
H A Dcmd.c192 wl1271_debug(DEBUG_CMD, "timeout waiting for event %d",
232 wl1271_debug(DEBUG_CMD, "cmd role enable");
274 wl1271_debug(DEBUG_CMD, "cmd role disable");
433 wl1271_debug(DEBUG_CMD, "cmd role start dev %d", wlvif->dev_role_id);
448 wl1271_debug(DEBUG_CMD, "role start: roleid=%d, hlid=%d, session=%d",
485 wl1271_debug(DEBUG_CMD, "cmd role stop dev");
519 wl1271_debug(DEBUG_CMD, "cmd role start sta %d", wlvif->role_id);
556 wl1271_debug(DEBUG_CMD, "role start: roleid=%d, hlid=%d, session=%d "
596 wl1271_debug(DEBUG_CMD, "cmd role stop sta %d", wlvif->role_id);
625 wl1271_debug(DEBUG_CM
[all...]
H A Dvendor_cmd.c38 wl1271_debug(DEBUG_CMD, "vendor cmd smart config start");
81 wl1271_debug(DEBUG_CMD, "testmode cmd smart config stop");
113 wl1271_debug(DEBUG_CMD, "testmode cmd smart config set group key");
H A Dscan.c44 wl1271_debug(DEBUG_SCAN, "Scanning complete");
231 wl1271_debug(DEBUG_SCAN, "n_pactive_ch = %d",
235 wl1271_debug(DEBUG_SCAN, "freq %d, ch. %d, flags 0x%x, power %d, min/max_dwell %d/%d%s%s",
328 wl1271_debug(DEBUG_SCAN, " 2.4GHz: active %d passive %d",
330 wl1271_debug(DEBUG_SCAN, " 5GHz: active %d passive %d",
332 wl1271_debug(DEBUG_SCAN, " DFS: %d", cfg->dfs);
388 wl1271_debug((DEBUG_CMD | DEBUG_SCAN), "cmd sched scan ssid list");
484 wl1271_debug(DEBUG_SCAN, "got periodic scan results");
H A Dmain.c251 wl1271_debug(DEBUG_TX, "No Tx (in FW) for %d ms due to ROC",
262 wl1271_debug(DEBUG_TX, "No Tx (in FW) for %d ms due to scan",
275 wl1271_debug(DEBUG_TX, "No Tx (in FW) for %d ms. AP has "
368 wl1271_debug(DEBUG_PSM,
399 wl1271_debug(DEBUG_IRQ, "intr: 0x%x (fw_rx_counter = %d, "
531 wl1271_debug(DEBUG_IRQ, "IRQ work");
582 wl1271_debug(DEBUG_IRQ, "WL1271_ACX_INTR_DATA");
617 wl1271_debug(DEBUG_IRQ, "WL1271_ACX_INTR_EVENT_A");
624 wl1271_debug(DEBUG_IRQ, "WL1271_ACX_INTR_EVENT_B");
631 wl1271_debug(DEBUG_IR
[all...]
H A Dtestmode.c79 wl1271_debug(DEBUG_TESTMODE, "testmode cmd test");
158 wl1271_debug(DEBUG_TESTMODE, "testmode cmd interrogate");
221 wl1271_debug(DEBUG_TESTMODE, "testmode cmd configure");
289 wl1271_debug(DEBUG_TESTMODE, "testmode cmd set plt mode");
H A Dtx.c58 wl1271_debug(DEBUG_CRYPT, "default wep key idx: %d", (int)id);
185 wl1271_debug(DEBUG_TX, "tx offchannel");
254 wl1271_debug(DEBUG_TX,
973 wl1271_debug(DEBUG_TX, "tx status id %u skb 0x%p failures %u rate 0x%x"
1008 wl1271_debug(DEBUG_TX, "tx_complete received, packets: %d", count);
1043 wl1271_debug(DEBUG_TX, "link freeing skb 0x%p", skb);
1117 wl1271_debug(DEBUG_TX, "freeing skb 0x%p", skb);
1166 wl1271_debug(DEBUG_MAC80211, "flushing tx buffer: %d %d",
1179 wl1271_debug(DEBUG_MAC80211, "tx flush took %d ms",
H A Drx.c195 wl1271_debug(DEBUG_RX, "rx skb 0x%p: %d B %s seq %d hlid %d", skb,
H A Dinit.c438 wl1271_debug(DEBUG_AP, "AP basic rate set: 0x%x",

Completed in 383 milliseconds