1/*
2 *  Created 20 Oct 2004 by Mark Lord
3 *
4 *  Basic support for Delkin/ASKA/Workbit Cardbus CompactFlash adapter
5 *
6 *  Modeled after the 16-bit PCMCIA driver: ide-cs.c
7 *
8 *  This is slightly peculiar, in that it is a PCI driver,
9 *  but is NOT an IDE PCI driver -- the IDE layer does not directly
10 *  support hot insertion/removal of PCI interfaces, so this driver
11 *  is unable to use the IDE PCI interfaces.  Instead, it uses the
12 *  same interfaces as the ide-cs (PCMCIA) driver uses.
13 *  On the plus side, the driver is also smaller/simpler this way.
14 *
15 *  This file is subject to the terms and conditions of the GNU General Public
16 *  License.  See the file COPYING in the main directory of this archive for
17 *  more details.
18 */
19
20#include <linux/types.h>
21#include <linux/module.h>
22#include <linux/ide.h>
23#include <linux/init.h>
24#include <linux/pci.h>
25
26#include <asm/io.h>
27
28/*
29 * No chip documentation has yet been found,
30 * so these configuration values were pulled from
31 * a running Win98 system using "debug".
32 * This gives around 3MByte/second read performance,
33 * which is about 2/3 of what the chip is capable of.
34 *
35 * There is also a 4KByte mmio region on the card,
36 * but its purpose has yet to be reverse-engineered.
37 */
38static const u8 setup[] = {
39	0x00, 0x05, 0xbe, 0x01, 0x20, 0x8f, 0x00, 0x00,
40	0xa4, 0x1f, 0xb3, 0x1b, 0x00, 0x00, 0x00, 0x80,
41	0x00, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00,
42	0x00, 0x00, 0x00, 0x00, 0xa4, 0x83, 0x02, 0x13,
43};
44
45static const struct ide_port_ops delkin_cb_port_ops = {
46	.quirkproc		= ide_undecoded_slave,
47};
48
49static int delkin_cb_init_chipset(struct pci_dev *dev)
50{
51	unsigned long base = pci_resource_start(dev, 0);
52	int i;
53
54	outb(0x02, base + 0x1e);	/* set nIEN to block interrupts */
55	inb(base + 0x17);		/* read status to clear interrupts */
56
57	for (i = 0; i < sizeof(setup); ++i) {
58		if (setup[i])
59			outb(setup[i], base + i);
60	}
61
62	return 0;
63}
64
65static const struct ide_port_info delkin_cb_port_info = {
66	.port_ops		= &delkin_cb_port_ops,
67	.host_flags		= IDE_HFLAG_IO_32BIT | IDE_HFLAG_UNMASK_IRQS |
68				  IDE_HFLAG_NO_DMA,
69	.irq_flags		= IRQF_SHARED,
70	.init_chipset		= delkin_cb_init_chipset,
71	.chipset		= ide_pci,
72};
73
74static int delkin_cb_probe(struct pci_dev *dev, const struct pci_device_id *id)
75{
76	struct ide_host *host;
77	unsigned long base;
78	int rc;
79	struct ide_hw hw, *hws[] = { &hw };
80
81	rc = pci_enable_device(dev);
82	if (rc) {
83		printk(KERN_ERR "delkin_cb: pci_enable_device failed (%d)\n", rc);
84		return rc;
85	}
86	rc = pci_request_regions(dev, "delkin_cb");
87	if (rc) {
88		printk(KERN_ERR "delkin_cb: pci_request_regions failed (%d)\n", rc);
89		pci_disable_device(dev);
90		return rc;
91	}
92	base = pci_resource_start(dev, 0);
93
94	delkin_cb_init_chipset(dev);
95
96	memset(&hw, 0, sizeof(hw));
97	ide_std_init_ports(&hw, base + 0x10, base + 0x1e);
98	hw.irq = dev->irq;
99	hw.dev = &dev->dev;
100
101	rc = ide_host_add(&delkin_cb_port_info, hws, 1, &host);
102	if (rc)
103		goto out_disable;
104
105	pci_set_drvdata(dev, host);
106
107	return 0;
108
109out_disable:
110	pci_release_regions(dev);
111	pci_disable_device(dev);
112	return rc;
113}
114
115static void
116delkin_cb_remove (struct pci_dev *dev)
117{
118	struct ide_host *host = pci_get_drvdata(dev);
119
120	ide_host_remove(host);
121
122	pci_release_regions(dev);
123	pci_disable_device(dev);
124}
125
126#ifdef CONFIG_PM
127static int delkin_cb_suspend(struct pci_dev *dev, pm_message_t state)
128{
129	pci_save_state(dev);
130	pci_disable_device(dev);
131	pci_set_power_state(dev, pci_choose_state(dev, state));
132
133	return 0;
134}
135
136static int delkin_cb_resume(struct pci_dev *dev)
137{
138	struct ide_host *host = pci_get_drvdata(dev);
139	int rc;
140
141	pci_set_power_state(dev, PCI_D0);
142
143	rc = pci_enable_device(dev);
144	if (rc)
145		return rc;
146
147	pci_restore_state(dev);
148	pci_set_master(dev);
149
150	if (host->init_chipset)
151		host->init_chipset(dev);
152
153	return 0;
154}
155#else
156#define delkin_cb_suspend NULL
157#define delkin_cb_resume NULL
158#endif
159
160static struct pci_device_id delkin_cb_pci_tbl[] = {
161	{ 0x1145, 0xf021, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
162	{ 0x1145, 0xf024, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
163	{ 0, },
164};
165MODULE_DEVICE_TABLE(pci, delkin_cb_pci_tbl);
166
167static struct pci_driver delkin_cb_pci_driver = {
168	.name		= "Delkin-ASKA-Workbit Cardbus IDE",
169	.id_table	= delkin_cb_pci_tbl,
170	.probe		= delkin_cb_probe,
171	.remove		= delkin_cb_remove,
172	.suspend	= delkin_cb_suspend,
173	.resume		= delkin_cb_resume,
174};
175
176module_pci_driver(delkin_cb_pci_driver);
177
178MODULE_AUTHOR("Mark Lord");
179MODULE_DESCRIPTION("Basic support for Delkin/ASKA/Workbit Cardbus IDE");
180MODULE_LICENSE("GPL");
181
182