1#
2# Atmel device configuration
3#
4
5config HAVE_NET_MACB
6	bool
7
8config NET_CADENCE
9	bool "Cadence devices"
10	default y
11	depends on HAVE_NET_MACB || (ARM && ARCH_AT91RM9200)
12	---help---
13	  If you have a network (Ethernet) card belonging to this class, say Y.
14	  Make sure you know the name of your card. Read the Ethernet-HOWTO,
15	  available from <http://www.tldp.org/docs.html#howto>.
16
17	  If unsure, say Y.
18
19	  Note that the answer to this question doesn't directly affect the
20	  kernel: saying N will just cause the configurator to skip all
21	  the remaining Atmel network card questions. If you say Y, you will be
22	  asked for your specific card in the following questions.
23
24if NET_CADENCE
25
26config ARM_AT91_ETHER
27	tristate "AT91RM9200 Ethernet support"
28	depends on ARM && ARCH_AT91RM9200
29	select NET_CORE
30	select MII
31	---help---
32	  If you wish to compile a kernel for the AT91RM9200 and enable
33	  ethernet support, then you should always answer Y to this.
34
35config MACB
36	tristate "Cadence MACB/GEM support"
37	depends on HAVE_NET_MACB
38	select PHYLIB
39	---help---
40	  The Cadence MACB ethernet interface is found on many Atmel AT32 and
41	  AT91 parts.  This driver also supports the Cadence GEM (Gigabit
42	  Ethernet MAC found in some ARM SoC devices).  Note: the Gigabit mode
43	  is not yet supported.  Say Y to include support for the MACB/GEM chip.
44
45	  To compile this driver as a module, choose M here: the module
46	  will be called macb.
47
48endif # NET_CADENCE
49