Cross Reference: /drivers/net/ethernet/alteon/acenic.c

Lines Matching defs:link
212  *  link=<val>  - Link state. Normally you want to use the default link
215  *                the link properly. Valid values are:
216  *         0x0001 - Force half duplex link.
218  *         0x0010 - 10Mbit/sec link.
219  *         0x0020 - 100Mbit/sec link.
220  *         0x0040 - 1000Mbit/sec link.
224  *                Default value is 0x0270, ie. enable link+flow
226  *                possible link speed with RX flow control enabled.
228  *                When disabling link speed negotiation, only one link
413 module_param_array_named(link, link_state, int, NULL, 0);
420 MODULE_PARM_DESC(link, "AceNIC/3C985/NetGear link state");
1379 	 * Default link parameters
1387 	 * Override link default parameters
1395 			printk(KERN_INFO "%s: Setting half duplex link\n",
1427 	ap->link = tmp;
1850 				printk(KERN_WARNING "%s: Optical link UP "
1859 				printk(KERN_WARNING "%s: Optical link DOWN\n",
1863 				printk(KERN_WARNING "%s: 10/100BaseT link "
1867 				printk(KERN_ERR "%s: Unknown optical link "
2601 	u32 link;
2613 	link = readl(&regs->GigLnkState);
2614 	if (link & LNK_1000MB)
2617 		link = readl(&regs->FastLnkState);
2618 		if (link & LNK_100MB)
2620 		else if (link & LNK_10MB)
2625 	if (link & LNK_FULL_DUPLEX)
2630 	if (link & LNK_NEGOTIATE)
2654 	u32 link, speed;
2656 	link = readl(&regs->GigLnkState);
2657 	if (link & LNK_1000MB)
2660 		link = readl(&regs->FastLnkState);
2661 		if (link & LNK_100MB)
2663 		else if (link & LNK_10MB)
2669 	link = LNK_ENABLE | LNK_1000MB | LNK_100MB | LNK_10MB |
2672 		link |= LNK_TX_FLOW_CTL_Y;
2674 		link |= LNK_NEGOTIATE;
2676 		link &= ~(LNK_1000MB | LNK_100MB | LNK_10MB);
2679 			link |= LNK_1000MB;
2682 			link |= LNK_100MB;
2685 			link |= LNK_10MB;
2691 		link |= LNK_FULL_DUPLEX;
2693 	if (link != ap->link) {
2695 		printk(KERN_INFO "%s: Renegotiating link state\n",
2698 		ap->link = link;
2699 		writel(link, &regs->TuneLink);
2701 			writel(link, &regs->TuneFastLink);