Lines Matching defs:polarity
37 e1000_rev_polarity *polarity);
767 * polarity value for the SW controlled pins, and setup the
2475 * are forced to 10H or 10F, then we will implement the polarity
3286 e1000_rev_polarity polarity;
3297 /* IGP01E1000 always correct polarity reversal */
3300 /* Check polarity status */
3301 ret_val = e1000_check_polarity(hw, &polarity);
3305 phy_info->cable_polarity = polarity;
3364 e1000_rev_polarity polarity;
3387 /* Check polarity status */
3388 ret_val = e1000_check_polarity(hw, &polarity);
3391 phy_info->cable_polarity = polarity;
5147 * e1000_check_polarity - Check the cable polarity
5149 * @polarity: output parameter : 0 - Polarity is not reversed
5155 * For phy's older than IGP, this function simply reads the polarity bit in the
5157 * 10 Mbps. If the link speed is 100 Mbps there is no polarity so this bit will
5158 * return 0. If the link speed is 1000 Mbps the polarity status is in the
5162 e1000_rev_polarity *polarity)
5175 *polarity = ((phy_data & M88E1000_PSSR_REV_POLARITY) >>
5187 * find the polarity status */
5198 /* Check the polarity bits */
5199 *polarity = (phy_data & IGP01E1000_PHY_POLARITY_MASK) ?
5203 /* For 10 Mbps, read the polarity bit in the status register. (for
5205 *polarity =