Lines Matching defs:on
303 /* Bit 12: (1) Duplicate data on both 20MHz chnls. HT40 (bit 11) must be set. */
501 * __le32 lmpm_pmg_sel; indicate which clocks are turned on (LMPM_PMG_SEL)
644 * table and txpower table before transmitting anything on the RXON
692 * specific rxon cmd, depending on where it is called from.
933 * with info on security keys, aggregation parameters, and Tx rates for
943 * new station table before transmitting anything on the RXON channel
947 * When getting started on a new channel, driver must set up the
1191 * The actual offsets of the hdr and end are dynamic based on
1225 __le64 timestamp; /* TSF at on air rise */
1226 __le32 beacon_time_stamp; /* beacon at on-air rise */
1232 __le16 frame_time; /* frame's time on the air */
1252 * (RTS/CTS/ACK), based on flags in the Tx command. uCode and Tx scheduler
1773 * when passed through ofdm_basic_rates on the C_RXON
2104 * 3945 and 4965 devices support hardware handshake with Bluetooth device on
2363 * 3) How long to stay on-channel (behavior may be modified by quiet_time,
2441 * long the device stays on an associated network channel ("service channel")
2448 * time that we stay on the service channel, doing normal work, between
2461 * 6) Checks to see if it has time to do scan on *next* channel in list
2466 * 10) Stays on service channel until suspend_time expires
2470 * For fast, efficient scans, the scan command also has support for staying on
2476 * For active scanning on channels that have regulatory restrictions against
2478 * that there is already legitimate activity on the channel. If enough
2479 * packets are cleanly received on the channel (controlled by good_CRC_th,
2492 __le16 quiet_time; /* dwell only this # millisecs on quiet channel
2536 __le16 quiet_time; /* dwell only this # millisecs on quiet channel
2737 __le32 non_channel_beacons; /* beacons with our bss id but not on
2828 __le32 non_channel_beacons; /* beacons with our bss id but not on
2864 * @ant_a: current tx power on chain a in 1/2 dB step
2865 * @ant_b: current tx power on chain b in 1/2 dB step
2866 * @ant_c: current tx power on chain c in 1/2 dB step
3012 * sensitivity calibration based on number of consecutive missed beacons in
3036 * 1) Tx power (depends on temperature), described elsewhere
3321 * this command turns it on or off, or sets up a periodic blinking cycle.
3327 * "0", with >0 "on" value, turns LED on */
3328 u8 on; /* # intervals on while blinking;