Cross Reference: /drivers/tty/cyclades.c

Lines Matching defs:routine
333 		const char *name, const char *routine)
338 				"in %s\n", name, routine);
344 				"struct (%s) in %s\n", name, routine);
354 /* This routine waits up to 1000 micro-seconds for the previous
761 /* The real interrupt service routine is called
1438  * This routine shuts down a serial port; interrupts are disabled,
1512  * This routine is called whenever a serial port is opened.  It
1773  * This routine is called when a particular tty device is closed.
1783 /* This routine gets called when tty_write has put something into
1787  * This routine will return the number of characters actually
1791  * enabling interrupts.  The interrupt service routine will then
1840  * This routine is called by the kernel to write a single
1841  * character to the tty device.  If the kernel uses this routine,
1842  * it must call the flush_chars() routine (if defined) when it is
1877  * This routine is called by the kernel after it has written a
1899  * This routine returns the numbers of characters the tty driver
1990  * This routine finds or computes the various line characteristics.
2082 		   later in this routine such a test is performed. */
2523  * cy_break() --- routine which turns the break handling on or off
2661  * This routine allows the tty driver to implement device-
2812  * This routine allows the tty driver to be notified when
2873 /* This routine is called by the upper-layer tty layer to signal
2914  * This routine notifies the tty driver that it should signal
4108 	   type of board has its own detection routine. If a board is found,
4110 	   routine. These functions are responsible for checking the