1/*
2 * Copyright (C) 2016 The Android Open Source Project
3 *
4 * Licensed under the Apache License, Version 2.0 (the "License");
5 * you may not use this file except in compliance with the License.
6 * You may obtain a copy of the License at
7 *
8 *      http://www.apache.org/licenses/LICENSE-2.0
9 *
10 * Unless required by applicable law or agreed to in writing, software
11 * distributed under the License is distributed on an "AS IS" BASIS,
12 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
13 * See the License for the specific language governing permissions and
14 * limitations under the License.
15 */
16
17package android.hardware.vibrator@1.0;
18
19interface IVibrator {
20  /**
21   * Turn on vibrator
22   *
23   * This function must only be called after the previous timeout has expired or
24   * was canceled (through off()).
25   * @param timeout_ms number of milliseconds to vibrate.
26   * @return vibratorOnRet whether vibrator command was successful or not.
27   */
28  on(uint32_t timeoutMs) generates (Status vibratorOnRet);
29
30  /**
31   * Turn off vibrator
32   *
33   * Cancel a previously-started vibration, if any.
34   * @return vibratorOffRet whether vibrator command was successful or not.
35   */
36  off() generates (Status vibratorOffRet);
37
38  /**
39   * Returns whether the vibrator supports changes to its vibrational amplitude.
40   */
41  supportsAmplitudeControl() generates (bool supports);
42
43  /**
44   * Sets the motor's vibrational amplitude.
45   *
46   * Changes the force being produced by the underlying motor.
47   *
48   * @param amplitude The unitless force setting. Note that this number must
49   *                  be between 1 and 255, inclusive. If the motor does not
50   *                  have exactly 255 steps, it must do it's best to map it
51   *                  onto the number of steps it does have.
52   * @return status Whether the command was successful or not. Must return
53   *                Status::UNSUPPORTED_OPERATION if setting the amplitude is
54   *                not supported by the device.
55   */
56  setAmplitude(uint8_t amplitude) generates (Status status);
57
58  /**
59   * Fire off a predefined haptic event.
60   *
61   * @param event The type of haptic event to trigger.
62   * @return status Whether the effect was successfully performed or not. Must
63   *                return Status::UNSUPPORTED_OPERATION is the effect is not
64   *                supported.
65   * @return lengthMs The length of time the event is expected to take in
66   *                  milliseconds. This doesn't need to be perfectly accurate,
67   *                  but should be a reasonable approximation. Should be a
68   *                  positive, non-zero value if the returned status is
69   *                  Status::OK, and set to 0 otherwise.
70   */
71  perform(Effect effect, EffectStrength strength) generates (Status status, uint32_t lengthMs);
72};
73