bb3e0eed9dd51987c7462bae2880a3d4d750c55a |
|
30-Oct-2009 |
Magnus Damm <damm@opensource.se> |
sh: Add R-standby sleep mode support Add R-standby specific bits to the SuperH Mobile sleep code. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
|
99675a7a45ed3cec54d6e1d11f13bcaacaf0909b |
|
30-Oct-2009 |
Magnus Damm <damm@opensource.se> |
sh: Add MMU and Cache handling sleep mode code Add MMU and cache handling functionality to the SuperH Mobile sleep code. The MMU and cache registers are saved and restored. The MMU is disabled and the cache is flushed and disabled before entering sleep modes if the SUSP_SH_MMU flag is set. This flag should be set in the case of R-standby and most likely for future U-standby support as well. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
|
323ef8dba67fb7b9c709457bd0374d88cfb8f25f |
|
30-Oct-2009 |
Magnus Damm <damm@opensource.se> |
sh: Rework SuperH Mobile sleep mode code Rework the SuperH Mobile sleep code from including board specific code to allowing each board to provide pre/post code snippets. These snippets should contain sdram management code to enter and leave self-refresh. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
|
b99610fb9cdf390965c62c22322596d961591160 |
|
11-Jul-2009 |
Matt Fleming <matt@console-pimps.org> |
sh: Provide diagnostic kernel stack checks Enable kernel stack checking code in both the dynamic ftrace and mcount code paths. Check the stack to see if it's overflowing and make sure that the stack pointer contains an address that's either in init_stack or after the bss. Signed-off-by: Matt Fleming <matt@console-pimps.org> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
|
2ef7f0dab6b3d171b6aff00a47077385ae3155b5 |
|
06-Mar-2009 |
Magnus Damm <damm@igel.co.jp> |
sh: hibernation support Add Suspend-to-disk / swsusp / CONFIG_HIBERNATION support to the SuperH architecture. To suspend, use "swapon /dev/sda2; echo disk > /sys/power/state" To resume, pass "resume=/dev/sda2" on the kernel command line. The patch "pm: rework includes, remove arch ifdefs V2" is needed to allow the generic swsusp code to build properly. Hibernation is not enabled with this patch though, a patch setting ARCH_HIBERNATION_POSSIBLE will be submitted later. Signed-off-by: Magnus Damm <damm@igel.co.jp> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
|
fc1c3a003edb8a6778e64e10ef671a38c76c969e |
|
29-Apr-2008 |
Christoph Lameter <clameter@sgi.com> |
sh: use kbuild.h instead of defining macros in asm-offsets.c Signed-off-by: Christoph Lameter <clameter@sgi.com> Cc: Paul Mundt <lethal@linux-sh.org> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
|
1da177e4c3f41524e886b7f1b8a0c1fc7321cac2 |
|
17-Apr-2005 |
Linus Torvalds <torvalds@ppc970.osdl.org> |
Linux-2.6.12-rc2 Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
|