1/*
2 *	linux/arch/alpha/kernel/pci_impl.h
3 *
4 * This file contains declarations and inline functions for interfacing
5 * with the PCI initialization routines.
6 */
7
8struct pci_dev;
9struct pci_controller;
10struct pci_iommu_arena;
11
12/*
13 * We can't just blindly use 64K for machines with EISA busses; they
14 * may also have PCI-PCI bridges present, and then we'd configure the
15 * bridge incorrectly.
16 *
17 * Also, we start at 0x8000 or 0x9000, in hopes to get all devices'
18 * IO space areas allocated *before* 0xC000; this is because certain
19 * BIOSes (Millennium for one) use PCI Config space "mechanism #2"
20 * accesses to probe the bus. If a device's registers appear at 0xC000,
21 * it may see an INx/OUTx at that address during BIOS emulation of the
22 * VGA BIOS, and some cards, notably Adaptec 2940UW, take mortal offense.
23 */
24
25#define EISA_DEFAULT_IO_BASE	0x9000	/* start above 8th slot */
26#define DEFAULT_IO_BASE		0x8000	/* start at 8th slot */
27
28/*
29 * We try to make the DEFAULT_MEM_BASE addresses *always* have more than
30 * a single bit set. This is so that devices like the broken Myrinet card
31 * will always have a PCI memory address that will never match a IDSEL
32 * address in PCI Config space, which can cause problems with early rev cards.
33 */
34
35/*
36 * An XL is AVANTI (APECS) family, *but* it has only 27 bits of ISA address
37 * that get passed through the PCI<->ISA bridge chip. Although this causes
38 * us to set the PCI->Mem window bases lower than normal, we still allocate
39 * PCI bus devices' memory addresses *below* the low DMA mapping window,
40 * and hope they fit below 64Mb (to avoid conflicts), and so that they can
41 * be accessed via SPARSE space.
42 *
43 * We accept the risk that a broken Myrinet card will be put into a true XL
44 * and thus can more easily run into the problem described below.
45 */
46#define XL_DEFAULT_MEM_BASE ((16+2)*1024*1024) /* 16M to 64M-1 is avail */
47
48/*
49 * APECS and LCA have only 34 bits for physical addresses, thus limiting PCI
50 * bus memory addresses for SPARSE access to be less than 128Mb.
51 */
52#define APECS_AND_LCA_DEFAULT_MEM_BASE ((16+2)*1024*1024)
53
54/*
55 * Because MCPCIA and T2 core logic support more bits for
56 * physical addresses, they should allow an expanded range of SPARSE
57 * memory addresses.  However, we do not use them all, in order to
58 * avoid the HAE manipulation that would be needed.
59 */
60#define MCPCIA_DEFAULT_MEM_BASE ((32+2)*1024*1024)
61#define T2_DEFAULT_MEM_BASE ((16+1)*1024*1024)
62
63/*
64 * Because CIA and PYXIS have more bits for physical addresses,
65 * they support an expanded range of SPARSE memory addresses.
66 */
67#define DEFAULT_MEM_BASE ((128+16)*1024*1024)
68
69/* ??? Experimenting with no HAE for CIA.  */
70#define CIA_DEFAULT_MEM_BASE ((32+2)*1024*1024)
71
72#define IRONGATE_DEFAULT_MEM_BASE ((256*8-16)*1024*1024)
73
74#define DEFAULT_AGP_APER_SIZE	(64*1024*1024)
75
76/*
77 * A small note about bridges and interrupts.  The DECchip 21050 (and
78 * later) adheres to the PCI-PCI bridge specification.  This says that
79 * the interrupts on the other side of a bridge are swizzled in the
80 * following manner:
81 *
82 * Dev    Interrupt   Interrupt
83 *        Pin on      Pin on
84 *        Device      Connector
85 *
86 *   4    A           A
87 *        B           B
88 *        C           C
89 *        D           D
90 *
91 *   5    A           B
92 *        B           C
93 *        C           D
94 *        D           A
95 *
96 *   6    A           C
97 *        B           D
98 *        C           A
99 *        D           B
100 *
101 *   7    A           D
102 *        B           A
103 *        C           B
104 *        D           C
105 *
106 *   Where A = pin 1, B = pin 2 and so on and pin=0 = default = A.
107 *   Thus, each swizzle is ((pin-1) + (device#-4)) % 4
108 *
109 *   pci_swizzle_interrupt_pin() swizzles for exactly one bridge.  The routine
110 *   pci_common_swizzle() handles multiple bridges.  But there are a
111 *   couple boards that do strange things.
112 */
113
114
115/* The following macro is used to implement the table-based irq mapping
116   function for all single-bus Alphas.  */
117
118#define COMMON_TABLE_LOOKUP						\
119({ long _ctl_ = -1; 							\
120   if (slot >= min_idsel && slot <= max_idsel && pin < irqs_per_slot)	\
121     _ctl_ = irq_tab[slot - min_idsel][pin];				\
122   _ctl_; })
123
124
125/* A PCI IOMMU allocation arena.  There are typically two of these
126   regions per bus.  */
127/* ??? The 8400 has a 32-byte pte entry, and the entire table apparently
128   lives directly on the host bridge (no tlb?).  We don't support this
129   machine, but if we ever did, we'd need to parameterize all this quite
130   a bit further.  Probably with per-bus operation tables.  */
131
132struct pci_iommu_arena
133{
134	spinlock_t lock;
135	struct pci_controller *hose;
136#define IOMMU_INVALID_PTE 0x2 /* 32:63 bits MBZ */
137#define IOMMU_RESERVED_PTE 0xface
138	unsigned long *ptes;
139	dma_addr_t dma_base;
140	unsigned int size;
141	unsigned int next_entry;
142	unsigned int align_entry;
143};
144
145#if defined(CONFIG_ALPHA_SRM) && \
146    (defined(CONFIG_ALPHA_CIA) || defined(CONFIG_ALPHA_LCA))
147# define NEED_SRM_SAVE_RESTORE
148#else
149# undef NEED_SRM_SAVE_RESTORE
150#endif
151
152#if defined(CONFIG_ALPHA_GENERIC) || defined(NEED_SRM_SAVE_RESTORE)
153# define ALPHA_RESTORE_SRM_SETUP
154#else
155# undef ALPHA_RESTORE_SRM_SETUP
156#endif
157
158#ifdef ALPHA_RESTORE_SRM_SETUP
159/* Store PCI device configuration left by SRM here. */
160struct pdev_srm_saved_conf
161{
162	struct pdev_srm_saved_conf *next;
163	struct pci_dev *dev;
164};
165
166extern void pci_restore_srm_config(void);
167#else
168#define pdev_save_srm_config(dev)	do {} while (0)
169#define pci_restore_srm_config()	do {} while (0)
170#endif
171
172/* The hose list.  */
173extern struct pci_controller *hose_head, **hose_tail;
174extern struct pci_controller *pci_isa_hose;
175
176extern unsigned long alpha_agpgart_size;
177
178extern void common_init_pci(void);
179#define common_swizzle pci_common_swizzle
180extern struct pci_controller *alloc_pci_controller(void);
181extern struct resource *alloc_resource(void);
182
183extern struct pci_iommu_arena *iommu_arena_new_node(int,
184						    struct pci_controller *,
185					            dma_addr_t, unsigned long,
186					            unsigned long);
187extern struct pci_iommu_arena *iommu_arena_new(struct pci_controller *,
188					       dma_addr_t, unsigned long,
189					       unsigned long);
190extern const char *const pci_io_names[];
191extern const char *const pci_mem_names[];
192extern const char pci_hae0_name[];
193
194extern unsigned long size_for_memory(unsigned long max);
195
196extern int iommu_reserve(struct pci_iommu_arena *, long, long);
197extern int iommu_release(struct pci_iommu_arena *, long, long);
198extern int iommu_bind(struct pci_iommu_arena *, long, long, struct page **);
199extern int iommu_unbind(struct pci_iommu_arena *, long, long);
200
201
202